Window Mosquito Screen Installation Guide

Installing a mosquito screen is simple once you know how the material behaves. A stable fit depends on clean surfaces, correct tension, and making sure the mesh sits flush along every edge.

Before You Begin

• Clean the window frame (dust reduces adhesion and weakens magnets)
• Open the window fully
• Set the mesh on a flat surface to avoid twists

Installation Methods

Choose the method that matches your type of screen.

1. Magnetic Window Screens

Steps

1. Position the magnetic frame strips on the window frame.
2. Press firmly for 10–15 seconds per section.
3. Lay the mesh over the frame, aligning top corners first.
4. Allow magnets to bond naturally — avoid stretching.
5. Check for gaps by shining a phone flashlight along the edges.

2. Adhesive Strip Screens

1. Peel a small section of adhesive — don't remove all at once.
2. Anchor the top edge first.
3. Work downward evenly along both sides.
4. Smooth gently to remove air pockets.
5. Trim excess mesh along the bottom if needed.

3. Aluminum Framed Screens

1. Insert the spline into the frame groove using a roller.
2. Keep the mesh slack while setting the first edge.
3. Apply tension gradually across the opposite side.
4. Trim the edges with a sharp blade at a 45° angle.
5. Snap the frame into the window recess.

Final Check

• No visible gaps
• Mesh lies flat without pulls or wrinkles
• Window opens and closes freely

A well-installed screen should stay tight and require almost no adjustment over the season.

Related Guides

• How to Measure a Window for a Mosquito Screen
• Why Mosquito Screen Mesh Sags in Humidity
• Back to Window Screens overview

---

View mosquito screens on Amazon →